Bowfishing Arrow Rest Aluminum Full Capture Roller Guide Archery Compound Bow Fishing

A1 Bowfishing Arrow Rest – Engineered. Not Assembled. Most bowfishing rests are just parts screwed together. The A1 is CNC-machined from a single block of 6061 aluminum – no plastic clips no stamped steel no compromises. Every surface every edge every tolerance was designed for one thing: making sure your arrow flies exactly where you aim it every time. TECHNICAL HIGHLIGHTS Material: 6061 Aircraft-Grade Aluminum Alloy Finish: Hard Anodized (MIL-A-8625 Type III) Weight: 56.7g / 2.0 oz (40% lighter than steel rests) Dimensions: 7.5 x 6.7 x 6 cm / 2.95 x 2.64 x 2.36 in Capture Type: 360-degree Full Containment Arrow Loading: Side Snap-In / Rear Feed-Through Guide System: Sealed Precision Roller Bearing Adjustment: Laser-Engraved Micro Scale 0.5mm Increments Anti-Tangle: Integrated Line-Deflector Geometry Hand Orientation: Ambidextrous (Right & Left) Mount: Standard Berger Hole Colors: Matte Black / Matte Green WHAT THIS MEANS FOR YOUR SHOT ✔1. Arrow Never Falls Off. The 360-degree capture ring physically prevents the arrow from leaving the rest until you release. On a rocking boat. In waist-deep water. At any draw angle. Your arrow stays exactly where you put it. ✔2. Friction Is Not Your Problem Anymore. A sealed roller bearing at the contact point spins freely under load. Heavy fiberglass bowfishing arrows that would grind against a standard rest now glide with minimal resistance. Result: faster arrow speed tighter groups less wear on your arrows. ✔3. Line Tangles Are Eliminated. The rest body incorporates angled deflector surfaces that push your bowfishing line away from the mechanism during release. No more wrapping. No more snapping back. No more losing fish because your line caught the rest. ✔4. Setup Is a One-Time Job. The laser-engraved scale gives you absolute reference points. Set windage and elevation to your bow. Tighten the lock screw. That zero stays locked – no drift no re-zeroing between outings. ✔5. Built for Saltwater. Built to Last. Type III hard anodizing is the same surface treatment used on military aircraft components. Salt spray? Hose it off. Mud? Wipe it down. The finish will outlast your bow. WHAT S INCLUDED A1 Bowfishing Arrow Rest x1 COMPATIBILITY All compound bows and recurve bows with a standard berger hole mount. NOT compatible with crossbows or youth bows with non-standard mounting patterns.